The Trantor industrial vacuum was designed for challenging applications and work environments like those found on construction sites or for post construction clean-up. The 2 bypass motors generate 250 CFM and 94.5 in. of water lift ideal for capturing large and fine debris and particulate which is first filtered cyclonically and then through a durable polyester cartridge filter with large surface area insuring clean air discharge. A galvanized cone overlaps a cast metal tangential entry point which enhances the cyclonic effect for separation of heavy debris helping to protect and preserve the life of the polyester cartridge filter. The Trantor is equipped with a filter shaker that helps to clean the surface of the cartridge filter during and after the vacuum is in operation. In applications where a power tool might be needed an 800-Watt grounded plug is mounted on the control panel of the vacuum. The plug is connected in such a way as to permit the vacuum to turn on when the power tool is powered allowing for source capture of debris when equipped for this purpose. The heavy-gauge 20 Gal. capacity stainless steel recovery bin is mounted on a steel trolley with heavy-duty casters to improve mobility in application where uneven surfaces or exterior use demands. The Trantor is targeted at applications demanding a durable vacuum such as construction site clean-up. Excels at hard wood floor sanding where the shaker feature maintains the vacuums performance.