Sirui W-2204K20 Carbon Fiber Tripod with K20X Ocean Runner Ball Head Kit

Time-Lapse Tips and Tools

The Sirui W-2204K20 Carbon Fiber Tripod with K20X Ocean Runner Ball Head Kit is a 4-section, 10-layer carbon fiber support with a load capacity of 39.7 lb. By unlocking the twist-locks, extending the legs, and pulling the rapid center column up, the tripod can reach a maximum height 74.9". With the legs splayed out and the column split to a short column, you can lower the tripod down to 10.1" off the ground.

Once you're done, you can fold the legs 180° in the reverse to make a compact 20.5" support. The waterproof leg design enables you to place the 4.6 lb support in a body of water or shoot in the rain without incurring any water damage. At the same time, one of the legs is detachable, and it can convert into a working monopod. To make the monopod taller, the center column can be attached to supplement the height of the monopod.

The aluminum, Arca-type K20X ball head has two separate locking knobs for the pan and ball movement, and at the same time, a tension control ring, which can be dialed to add or decrease the drag of the ball, is built into the main locking knob. Three bubble levels are located on the ball head, so this helps you to level out at every axis. Also, the TY-50X quick release plate is included with the ball head.

• The Sirui W-2204K20 Carbon Fiber Tripod with K20X Ocean Runner Ball Head Kit is a 4-section, 10-layer carbon fiber support with a load capacity of 39.7 lb. By unlocking the twist-locks, extending the legs, and pulling the rapid center column up, the tripod can reach a maximum height 74.9". With the legs splayed out and the column split to a short column, you can lower the tripod down to 10.1" off the ground.
Once you're done, you can fold the legs 180° in the reverse to make a compact 20.5" support. The waterproof leg design enables you to place the 4.6 lb support in a body of water or shoot in the rain without incurring any water damage. At the same time, one of the legs is detachable, and it can convert into a working monopod. To make the monopod taller, the center column can be attached to supplement the height of the monopod.
The aluminum, Arca-type K20X ball head has two separate locking knobs for the pan and ball movement, and at the same time, a tension control ring, which can be dialed to add or decrease the drag of the ball, is built into the main locking knob. Three bubble levels are located on the ball head, so this helps you to level out at every axis. Also, the TY-50X quick release plate is included with the ball head.