Klein Tools 3-Piece AC/DC Voltage Tester, 12V-1000-Volt AC Dual Range Non-Contact Voltage Tester & GFCI Receptacle Tester Tool Set M2O41267KIT

About This Product

This 3-Piece Tool Set includes Cat. No. NCVT2P Dual Range Non-Contact Voltage Tester, 12 - 1000-Volt AC, Cat. No. ET60 AC/DC Voltage Tester, and Cat. No. RT210 GFCI Receptacle Tester. The NCVT2P is a non-contact voltage tester that detects 12 to 1000V AC and indicates the presence of voltage in cables, cords, circuit breakers, light fixtures, switches, outlets and wires as well as AC voltage in doorbells, thermostats, low voltage lighting and irrigation systems. The ET60 is a solid-state, low impedance, electronic voltage tester. It measures AC/DC voltages up to 600V. The ET60 does NOT require batteries; it is powered by the applied voltage. The GFCI Outlet tester is designed to detect the most common wiring problems in standard and GFCI receptacles. A convenient chart on the tester helps determine wiring condition in outlet, based on LED lights results. Conditions indicated: open ground, reverse polarity, open hot, open neutral, hot/ground reversed.

Highlights

Tool set includes non-contact voltage tester, AC/DC voltage tester and outlet tester

Dual range non-contact voltage tester indicates low voltage (12-Volt to 48-Volt AC) and standard voltage (70-Volt to 1000-Volt AC) allowing broad application

Detects 12-Volt to 1000-Volt AC with simultaneous visual and audible voltage indicators

Non-contact detection of low voltage in security, entertainment, communications, environmental control and irrigation systems

Lightweight, compact tool with pocket clip provides convenient storage and quick access

CAT IV 1000 V rating provides expanded operation and protection

Screw-thread battery cap with O-ring ensures protection against dust and water ingress

IP67: dustproof and waterproof

ET60 tests AC/DC voltage from 12-Volt-600-Volt at 9 useful levels aligned with commonly used voltages

Uses standard replaceable multimeter test leads for versatility

CAT IV 600-Volt modern solid-state design for safety

Easy to use bright LED display clearly reports the voltage present in the circuit being tested

Integrated test-lead holders are used for lead storage or for holding the probes correctly spaced for insertion into tamper-resistant US-style outlets

Inherent low input impedance reduces the possibility of falsely reading ghost or stray voltages on non-energized circuits

Batteries not required, as tester is powered by the applied voltage in the circuit being tested

Outlet tester detects the most common wiring problems in standard and GFCI receptacles

Works on GFI outlets and confirms operation of the ground fault protective device

Conditions indicated: open ground, reverse polarity, open hot, open neutral, hot/ground reversed